McCrometer ProComm GO Instructions

Battery Installation and Replacement Procedure
for the ProComm GO Converter
This procedure applies to Dura Mag and McMag3000 flow meters with the ProComm GO
converter. It describes how to install batteries in a new meter and how to replace batteries using
the replacement battery kit PGK01.
Before you begin:
Check materials and tools to ensure you have everything you need.
Materials Provided (shown in order of use)
One triple D battery pack
Zip ties:
• 2 large
• 1 small
I. Removing the cover
1. Cut off the tamper-proof seal and remove the wire
from the security screw.
NOTE: This step is not required for battery installation
in new meters.
If you are replacing batteries with fresh batteries,
3
continue to step .
ProComm GO Battery Installation and Replacement
One double A battery pack
Tamper proof
Dry pack
Security screw
Cut wire
Page 1
Replacement
cover gasket
Tool Required
wire seal
Wire cutters
Phillips screwdriver
5/32" Allen driver
2. Remove screws holding
the lid to the housing
using a 5/32" Allen driver.
Lift the lid up and place
the lid upside hanging by
the green ground wire.
If you are installing batteries in a new meter
that does not have batteries already installed,
D M
®
URA AG
Mag
3000
Molykote
lubricant
9
go to step .
30125-57 Rev. 1.0 | 04OCT2021