Table of Contents
Advertisement
3 START
3.1 Starting EASE1000
This section describes how to start EASE1000.
For the following software running on the host PC, see the appropriate user's manual.
- DTU8 User's Manual
- MWU16 Flash Multi Writer Host Program User's Manual
3.1.1 Starting Procedure
Start EASE1000 according to the following procedure.
(1) Connect EASE1000 with the target system through the supplied EASE1000 interface cable.
(2) Connect EASE1000 with the host PC though the supplied USB cable.
EASE1000 is USB bus-powered. When the USB cable is connected to EASE1000, EASE1000 is turned on, and
the POWER indicator on EASE1000 lights up in green.
(3) Turn on the target system.
(4) Start the software on the host PC.
EASE1000 interface cable
Target LSI
Target system
Note
Note
FEXTEASE1000-02
EASE1000
Figure 3-1 EASE1000 System Diagram
Be sure to start according to the starting procedure.
Failing to obey the procedure may damage EASE 1000 or the target system, or cause an
electric shock or fire.
Be sure to use the cables attached to EASE 1000.
Using different cables may damage EASE 1000 or the target system, or cause an electric shock
or fire.
Host PC
USB cable
EASE1000 User's Manual
Chapter 3 START
・DTU8 Debugger
・MWU16 Flash Multi Writer
host program
1
Advertisement
Table of Contents
