Connection For Ease1000 (Cne); Led (P20, P21, P22) - LAPIS Semiconductor ML62Q1367 User Manual

2.2. Connection for EASE1000 (CNE)

EASE1000 can be used if J1 and J2 jumper are set to "CNE".
ML62Q1367
RESET_N
P00/TEST0
[Note]
P00/TEST0 pin:
P00/TEST0 pin of ML62Q1367 is initially set as a pull-up input mode
When using EASE1000, do not set it as an output mode by using an application program, otherwise EASE1000
cannot communicate with the ML62Q1367.

2.3. LED (P20, P21, P22)

The P20-P22 pins of the ML62Q1367 are ports that can directly drive LED. The Ports are connected to the LEDs through
jumper-chip. Remove the jumper-chip when not using the LEDs.
FEBL62Q1367RB
VDD
J1
CNE
10k
C
USR
J2
CNE
C
USR
Fig. 3 EASE1000 Interface
Fig. 4 Jumper-chip removal of LEDs
ML62Q1367 Reference Board User's Manual
CNE
5
RST_OUT/SCK
7
SDATA
CN1
6
RESET_N
7
P00/TEST0
Remove when not
using the LEDs
4