Lowrance Active Imaging 3-IN-1 Installation Manual page 17

careful that the cable is properly routed between the transom
mount plate and the transducer mount plate.
12.
Slide the second M6 bolt into the bottom hole you drilled on
the side of the jackplate, the transducer mount plate holes and
the transom mount plate holes.
13.
Attach the M6 nut to the end of the bolt and tighten the nut.
14.
Route the transducer cable to the location where the display or
sonar module is installed.
15.
Connect the transducer cable to the sonar port on the display or
sonar module.
After the transducer is connected and your boat is in the water,
ensure what is shown on the left and right side on your display
corresponds with what is on the left and right side of your boat. If
they are showing opposite of what they should, turn on the Flip
Left/Right feature in your display unit to correct it. Refer to your
display unit's Operation manual for more information.
Installation | Active Imaging transducers Installation Manual
17