Lowrance Active Imaging 3-IN-1 Installation Manual page 14

14
Direct step mount installation
Ú Note:
Do not install the transducer under the hull.
You can mount the transducer in either direction; with the cable
coming out towards or away from the transom when installing with
the direct step (Flush bracket) mount. However, after the transducer
is connected and your boat is in the water, you need to check what
is shown on the left and right side on your display corresponds with
what is on the left and right side of your boat. If they are showing
opposite of what they should, turn on the Flip Left/Right feature in
your display unit to correct it. Refer to your display unit's Operation
manual for more information.
Ú Note:
Sonar does not track bottom when the transducer is out
of the water.
Direct step mount bracket and supplies (not included)
Pilot hole drill bit (Direct Step
mount pilot holes for self-
tapping metal screws)
Maximum 5 mm (#10 or 3/16")
self-tapping metal screws
To direct step mount using flush bracket
1.
Make sure the boat's step is the same length or longer than the
transducer.
2.
After selecting a mounting location, route the transducer cable
to the location where the display or sonar module is or will be
installed.
Installation | Active Imaging transducers Installation
Manual
X
Marine high-grade above- or
below-waterline sealant/
adhesive compound