Lowrance Active Imaging 3-IN-1 Installation Manual page 11

1.
Attach the transducer to the bracket mount plate using the 6
M4 attachment screws and M4 lock washers.
2.
Loosely attach the transducer bracket mount plate to the
transom mount plate using M6 screws and nuts. Be careful to
run the cable between the bracket mount plate and the
transom mount plate before inserting the screws.
3.
Choose a transducer location.
4.
Place the bracket against the transom and then align the
bottom of the transducer with the bottom of boat. Use a pencil
to mark the pilot holes through the slots in the transom mount
plate.
5.
Drill the pilot holes into the boat's transom.
6.
Apply a marine high-grade above- or below-waterline sealant/
adhesive compound to the pilot holes.
7.
Align the transom mount plate screw slots over the pilot holes
and fasten the bracket to the transom using the supplied
screws.
8.
To make adjustments to transducer position, loosen the screws
and slide bracket up or down.
9.
Set the angle of the transducer, and tighten the M6 screws that
attach the transducer bracket mount plate to the transom
mount plate.
10.
Route the transducer cable to the location where the display or
sonar module is installed.
11.
Connect the transducer cable to the sonar port on the display or
sonar module.
After the transducer is connected and your boat is in the water,
ensure what is shown on the left and right side on your display
corresponds with what is on the left and right side of your boat. If
they are showing the opposite sides of what they should, turn on
the Flip Left/Right feature in your display unit to correct it. Refer to
your display unit's Operation manual for more information.
Installation | Active Imaging transducers Installation Manual
11