Table of Contents
Advertisement
Mounting the inverter
6.2
Installing the DC and AC isolator switches
NOTE
To prevent damage to the DC and AC isolator switches during transport, both isolator switches are
enclosed with the unit in an installation bag.
Figure 8: Installing the DC and AC isolator switches
Key
1
DC and AC isolator switches
2
Sealing ring with ON / OFF label
Installing the DC and AC isolator switches
↻ You have set up the unit and secured it.
1.
Open both door locks with a suitable slotted-head screwdriver. (Blade width (8 mm) cf. ISO 2380-2)
2. Slowly open the doors.
3. Remove and open the installation bag containing the DC/AC isolator switches from the unit.
4. Press the back of the DC/AC isolator switches to the intended opening of the doors so that the switch is pointing
down and the label "ON" is up.
↻ The sealing ring with the label ON / OFF must be attached fl ush against the door wall.
5. Place the screws with washers in the holes of the doors and start the threads of the isolator switch.
6. Use a suitable cross- or slotted-head screwdriver to tighten the screws. (Tightening torque is 1.5 Nm)
7.
Check that the switch works and is sealed properly. (Protection class IP54)
8. Move the switch to the OFF position.
9. Check the positioning of the switch for the DC/AC isolator switch and to make sure it is properly seated.
10. Close doors slowly so that the switching bar is inserted directly in both isolator switch.
11. Secure the door locks on the housing.
»
Install the inverter.
Page 16
4
3
2
1
3
Screws (M4x8)
4
Plain washer
Installation Instructions KACO
blueplanet
32.0 TL3 / 40.0 TL3 / 50.0 TL3
Advertisement
Table of Contents
