Table of Contents
Advertisement
6.2 The Single-Traverse Method -GCF (cont.)
8. Center one of the blocks over one of the crossmarks on the pipe. Align the block so that the pressure bolt is over the
center of the crossmark. Secure the block by wrapping two straps around the block and the pipe and tightening
them. Make sure the turnbuckles are at least 1/2 pipe diameter away from the block.
9. Repeat Step 8 to install the other block over the other crossmark.
Note: Make sure the straps are perpendicular to the bottom of the blocks. If the straps are slanted, the blocks may
move and this could change the final transducer spacing.
26
Turnbuckles
Top View
Top View
C-RS Ultrasonic Flow Transducer Installation Guide
Advertisement
Table of Contents
