Table of Contents
Advertisement
5.4 The Single-Traverse Method -UCF (cont.)
9. Use the wing nuts to tighten the chains on the long block until it is secured snugly to the pipe.
Note: Make sure the chains are perpendicular to the clamping fixture and are not twisted. If the chains are slanted,
the fixture may move and this could change the final transducer spacing.
10. Position the clamping fixture rails so that one of the short blocks is placed over the remaining crossmark on the
opposite side of the pipe and the pressure bolt is over the center of the crossmark. Make sure the block does not lie
on top of the long block chains.
14
Tighten Screw
Hooks
Crossmark
Crossmark
Short Block
(One of two)
Top View
C-RS Ultrasonic Flow Transducer Installation Guide
Top View
Advertisement
Table of Contents
