Mira Advance Installation, Operation, Maintenance Manual page 36

Section
11
1. Cleaning 1. Cleaning
1. Cleaning 1. Cleaning 1. Cleaning
Read the section "Important Safety Information"
1.1. 1.1. 1.1. 1.1. 1.1. Many household cleaners contain abrasives and chemical substances, and
should not be used for cleaning plated or plastic fittings. These finishes should
be cleaned with a mild washing up detergent or soap solution, and then wiped
dry using a soft cloth.
1.2. 1.2. 1.2. Spray pattern deterioration can be caused by either, debris trapped in the spray
1.2. 1.2.
head, or a limescale buildup in the spray holes. The spray head can be removed
and cleaned in a proprietary plastic kettle descalent, following the manufacturer's
instructions.
1.3. 1.3.
1.3. To clean the head or spray plate, please refer to the appropriate section in the 1.3. 1.3.
Installation, Operation and Maintenance Guide which accompanies the shower
fittings.
2. 2. 2. 2. 2. Mir Mira Adv Mir Mir a Adv a Advance Co a Adv ance Cov v v v v er – Remo ance Co ance Co
Mir a Adv ance Co
2. 2. 2. 2. 2.1. 1. 1. 1. 1. To remove the cover:
2.1.1. 2.1.1. 2.1.1. Remove the screw located at 2.1.1. 2.1.1.
the bottom of Mira Advance
case.
2.1.2. C a u t i o n ! 2.1.2. 2.1.2. C a u t i o n ! C a u t i o n ! C a u t i o n !
2.1.2. 2.1.2. C a u t i o n !
connected
case by wire 78 Multi-
connector, which should not be
strained when carrying out the
next instruction (Refer to Figure
4).
2.1.3. Carefully pull the bottom of 2.1.3. 2.1.3.
2.1.3. 2.1.3.
cover outwards and upwards
off case.
2.1.4. 2.1.4.
2.1.4. 2.1.4. Carefully remove the wire 78 2.1.4.
multi-connector from the socket
on the control PCB, in the cover
if the maintenance procedure
requires.
36 36
36 36 36
Maintenance Maintenance Maintenance
Maintenance Maintenance
"Important Safety Information" first. "Important Safety Information" "Important Safety Information"
"Important Safety Information"
er – Remov v v v v al and Refitting er – Remo er – Remo
er – Remo
The cover
to
al and Refitting al and Refitting al and Refitting
al and Refitting
is
the
Flow
INLET
Wire 78 Multi- connector
Figure 4 Figure 4 Figure 4
Figure 4 Figure 4
Serial No. ASHMEAD
Mira Advance 8.7M
240V ~ 8.7kW
230V ~ 8.0kW
0.5 - 10 BAR
OPEN OUTLET 0 BAR IP34
Caradon Mira Ltd. Cheltenham GL52 5EP