Mira Advance Installation, Operation, Maintenance Manual page 19

↑
40 mm
Earth Sleeve
Priming the Mira Advance Priming the Mira Advance Priming the Mira Advance Priming the Mira Advance Priming the Mira Advance
Connect the shower hose to the
Mira Advance and position the hose
to discharge into the shower tray or
bath waste outlet. Press the air
bleed button, located on top of the
flow valve, several times. This will
allow the Mira Advance to fill with
water and expel any entrapped air.
Note! Note!
Note! Failure to prime the unit will Note! Note!
severely effect performance.
Note! Note! Water at full mains supply Note!
Note! Note!
pressure will flow from the shower
Air Bleed
hose and a small amount of water
Button
will be discharged from under the air
bleed button.
Caution! Caution!
Caution! Once the air bleed button Caution! Caution!
has been pressed ensure that is
not fouled when released, otherwise
water will continue to discharge from
the bleed button.
1.16. 1.16. Bring the electrical supply cable 1.16.
1.16. 1.16.
into the case via one of the cable
entry points, and offer up to the
terminal block.
1.17. 1.17. Strip back approximately 40 mm of 1.17. 1.17. 1.17.
the
Fit the earth sleeve over the earth
conductor.
Connect the conductors firmly into
the terminal block (refer to wiring
diagram). Ensure that the bare cores
of each conductor are securely
trapped within
clamp.
L = Red Wire
N = Black Wire
outer cable
within within
within within each conductor
= Yellow/Green sleeved wire
insulation.
19 19
19 19 19