Mira Advance Installation, Operation, Maintenance Manual page 22

7. 7. 7. 7. 7. Press Press the 'MEDIUM' Press Press Press
green indicator and the audible tone. Allow the Mira Advance to operate for
2 minutes.
8. 8. 8. 8. 8. Press Press Press the 'HIGH' Press Press
indicator and the audible tone. Allow the Mira Advance to operate for
2 minutes.
9. 9. 9. 9. 9. Turn Turn the 'TEMPERATURE' Turn
Turn Turn
'TEMPERATURE' control from cold through to position number 6 'TEMPERATURE' 'TEMPERATURE'
'TEMPERATURE' 'TEMPERATURE'
typical showering temperature. If a satisfactory temperature cannot be achieved,
then turn the 'TEMPERATURE'
Note! Note! Changing the temperature requires the Note!
Note! Note!
staged power up and power down of individual
heating elements. During this sequence the
user may hear a number of audible 'clicks' from
the relays.
10. 10. Press Press
10. 10. 10. Press the 'MEDIUM' Press Press
water will decrease, but the selected temperature
will remain relatively constant.
11. 11. Press Press
11. 11. 11. Press the 'LOW' Press Press
will decrease, but the selected temperature will
remain relatively constant.
12. 12. 12. Press the 'STOP' button and observe the red indicator and audible tone. Press the 'STOP' button and observe the red indicator and audible tone. Press the 'STOP' button and observe the red indicator and audible tone.
12. 12. Press the 'STOP' button and observe the red indicator and audible tone. Press the 'STOP' button and observe the red indicator and audible tone.
The Mira Advance will continue to run for a few seconds before shutting The Mira Advance will continue to run for a few seconds before shutting The Mira Advance will continue to run for a few seconds before shutting
The Mira Advance will continue to run for a few seconds before shutting The Mira Advance will continue to run for a few seconds before shutting
off. Audible 'clicks' will be heard. off. Audible 'clicks' will be heard. off. Audible 'clicks' will be heard.
off. Audible 'clicks' will be heard. off. Audible 'clicks' will be heard.
Note! Note! To ensure the commissioning process is memorised by the Mira Advance Note!
Note! Note!
the STOP STOP STOP button must be pressed before electrically isolating the Mira Advance. STOP
STOP
Note! Note! Water may continue to drip for a short time whilst the water drains out of Note! Note! Note!
the handset .
Note! Note! Note! High cold water mains supply pressures and high shower temperatures Note! Note!
will cause a slight audible hissing sound to be heard from the Mira Advance whilst
it is operating. This is quite normal and does not indicate that there is a fault with
the Mira Advance.
22 22
22 22 22
'MEDIUM' 'MEDIUM' flow button and observe an increase in flow of water, the 'MEDIUM' 'MEDIUM'
'HIGH' 'HIGH' flow button and observe an increase in flow of water, the green 'HIGH' 'HIGH'
'TEMPERATURE' control to cold and then slowly 'TEMPERATURE' 'TEMPERATURE'
'TEMPERATURE'
'TEMPERATURE' 'TEMPERATURE'
'TEMPERATURE' 'TEMPERATURE' control through to position number 8
'MEDIUM' 'MEDIUM'
'MEDIUM' flow button. The flow of 'MEDIUM'
'LOW' 'LOW'
'LOW' 'LOW' flow button. The flow of water
slowly turn the slowly slowly
slowly
number 6, which is a number 6 number 6
number 6
number 8 number 8
number 8. number 8
Flow