Mira Advance Installation, Operation, Maintenance Manual page 18

DO NOT DO NOT DO NOT DO NOT connect directly back into DO NOT
the wall.
1.11. 1.11. Thoroughly flush the mains-fed Thoroughly flush the mains-fed
1.11.Thoroughly flush the mains-fed 1.11. 1.11. Thoroughly flush the mains-fed Thoroughly flush the mains-fed
cold water supply pipe. The cold water supply pipe. The cold water supply pipe. The
cold water supply pipe. The cold water supply pipe. The
supply must be clean and free supply must be clean and free supply must be clean and free
supply must be clean and free supply must be clean and free
from debris from debris BEFORE from debris
from debris from debris
the Mira Advance the Mira Advance the Mira Advance the Mira Advance the Mira Advance.
Note! Debris will reduce the Note! Debris will reduce the
Note! Debris will reduce the Note! Debris will reduce the Note! Debris will reduce the
performance of the unit. performance of the unit.
performance of the unit. performance of the unit. performance of the unit.
1.12. Avoiding buried cables and pipes, 1.12. 1.12.
1.12. 1.12.
choose one of the upper fixing
holes which will allow the Mira
Advance to be firmly fixed to the
wall structure, and drill through the
thinned hole section in the back of
the case.
1.13. 1.13. Offer the Mira Advance up to the 1.13.
1.13. 1.13.
wall and temporarily connect the
mains-fed cold water supply pipe.
Mark through the casing the
position of the upper and lower
holes. Remove the Mira Advance
from the wall before drilling. This
will prevent debris from entering
the Mira Advance.
1.14. 1.14. 1.14. 1.14. 1.14. Drill and suitably plug the two fixing
holes. Secure the Mira Advance to
the wall with the screws provided.
Alternative fixings (not supplied)
may be necessary for some wall
structures.
1.15. Make the connection to the mains- 1.15. 1.15. 1.15. 1.15.
fed cold water supply pipe. Hold a
wrench across the flats of the inlet
connector assembly to prevent
damage to the connector, whilst
tightening the compression nut.
Turn on the water supply.
18 18
18 18 18
BEFORE connecting BEFORE BEFORE connecting connecting connecting
BEFORE connecting
Upper Fixing Holes
Lower Fixing Holes
INLET