To Select Analog Output Or Proportional Control - Omega CN1001-TC User Manual

15.3 To Select Analog Output or Proportional Control

To determine if the meter is to transmit an analog signal out proportional to your display or
proportional to the error (proportional control) (The error is defined as the difference between
reading and Setpoint 1 value).
If you have selected "S.3=P" in Setpoint 1 Configuration ("S1.CF" - refer to Section 11), you
cannot program the meter for analog output proportional control. You may, however, use the
regular analog output. If you have selected "S.3=0" in Setpoint 1 Configuration, then you may
select analog output or proportional control as follows.
1. Press the
* "O.3=A"
* "O.3=P"
2. Press the
3a. If you select O.3=A, press the MENU button to store your choice. The meter momentarily
shows "STRD", followed by "OT.S.O" (Output Scale and Offset- refer to Section 18).
3b. If you select O.3=P, press the
* "O.4=D"
* "O.4=R"
4. Press the
5. Press the MENU button to store your choice. The meter momentarily shows "STRD",
followed by "P.BND" (Proportional Band).
Additionally, if you select O.2=V (Analog output to be voltage), press the
The meter shows one of the following:
* "O.5=F"
* "O.5=H"
6. Press the
7. Press the MENU button to store your choice(s). The meter momentarily shows "STRD",
followed by "P.BND" (Proportional Band).
/DEV button. The meter shows one of the following:
(Analog output is retransmission of temperature) (Factory default)
(Analog output is proportional to error between display reading and
Setpoint 1)
/MAX button to toggle between choices.
(Proportional analog output is DIRECT ACTING)
(Proportional analog output is REVERSE ACTING).
/MAX button to toggle between choices.
(Proportional 0-10 V analog output)
(Proportional 0-5 V analog output)
/MAX button to toggle between choices.
/DEV button. The meter shows one of the following:
22 22
/DEV button.