Output Scale And Offset (Ot.s.o) - Omega CN1001-TC User Manual

Output Scale and Offset (OT.S.O) is not active unless your meter has analog output capabilities.
The menu will display whether analog output is present or not. Output Scale and Offset
(OT.S.O) scales your analog output to be equal to the meter's display and/or any engineering
units you require. You may scale the output for direct (4-20 mA, 0-10 V, etc) or reverse acting
(20-4 mA, 10-0 V, etc).
"OT.S.O" only shows if you select analog output as a retransmission of temperature.
1. Press the MENU button until the meter shows "OT.S.O".
2. Press the
This is your first point of display reading.
3. Press the
number (-1999 through 9999) with flashing 4th digit.
4. Press the
5. Press the
6. Press the MENU button to store your selection. The meter shows "OUT.1" (Output 1).
This starting analog signal corresponds to your Read 1 display.
7. Press the
If you select "0.2=V" for voltage, the maximum signal you may select is 10.00 for
an 0-10 V dc signal output. If you select "0.2=C" for current, the maximum
signal you may select is 20.00 for a 0-20 or 4-20 mA dc signal output.
8. Press the
the /MAX button, the flashing digit's value continues to change.
SECTION 18. OUTPUT SCALE AND OFFSET (OT.S.O)
/DEV button. The meter shows "RD 1" (Read 1) .
/DEV button again. The meter shows the last previously stored 4-digit
/MAX button to change the value of Read 1.
/DEV button to scroll to the next digit.
/DEV button. The meter shows selected output.
/MAX button to enter the output 1 signal selection. If you continue to press
25 25