LAUNCH TECH Pilot TPMS User Manual page 17

LAUNCH
3. Choose the desired system language, and tap "Next".
4. Choose the desired time zone, and tap "Next" to enter the WLAN setup page.
5. Slide the switch to ON, the system starts searching for all available wireless
LANs. Choose the desired WLAN access point / network,
• If the network you chose is open, you can connect directly;
• If the selected network is encrypted, you have to enter the right security
key (network password).
*Note: If you choose "Ignore" in WLAN setup, it will go into the date setting page. If the
tool has been properly connected to the Internet, the system will automatically obtain
the correct network date and time and navigate to step 6.
6. After the network connection is done, tap "Next" to configure email address.
Input the email address, and tap "Next" to navigate to the Job menu.
*Note: You are strongly recommended to fill in the valid email address. Once you
configured this option, the system will automatically send the diagnostic report to your
email box every time a complete Auto-Detect process is successfully finished.
Figure 4-2
Pilot TPMS User's Manual
EN
11