Advertisement
TO THE USER
This equipment has been tested to FCC requirements and has Deen found acceptable for use. The FCC require:, the follqwing
statement for your information:
This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in stri:-: accordance
with the manufacturer's instructions may cause interference to radio and te!evbon reception. It has been type tested and found
to comply with the limits for a Class B computing device in accordance with the specifications in Subpart J of Part 15 of FCC
Rules, which are designed to provide reasonable protection against such interference in a residential installation. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to
radio or television reception, which can be determined by turning the equipment off and on. the user is encouraged to try to
Correct the interference by one or more of the following measures:
l
If using an indoor antenna, have a quality outdoor antenna installed.
l
Reorient the receiving antenna until interference is reduced or eliminated.
l
Move the receiver away from the control/communicator.
l
Plug the control/communicator
into a different outlet so that it and the receiver are on different branch circuits.
l
Move the antenna leads away from any wire runs for control/communicator.
If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. The user
may find the following booklet prepared by the Federal Communications Commission helpful:
"HOW
to Identify and Resolve Radio-TV Interference Problems."
This booklet is available from the U.S. Government Printing Office, Washington, DC 20402. Stock No. 004-000-00345-4.
tn the event Of telephone operational problems, disconnect the control/communicator
by removing the plug from the RJSt X jack.
We recommend your certified installer demonstrate disconnecting the phones on installation of the system. Do not disconnect the
phone connection inside the control/communciator.
Doing so will result in the loss of your phone lines. If your regular phone
works correctly after the control/communicator
has been disconnected from the phone lines, the control/communicator
has a
problem and should be returned for repair. If upon disconnection of the control/communicator.
there is still a problem on your line,
notify the telephone company that they
have a
problem and request prompt repair service. The user may not under any
circumstances (in or out of warranty) attempt any service or repairs on the system. It must be returned to the factory or an
authorized service agency for all repairs.
NOTE: When the system is communicating with the central
alarm monitoring
service, the phone line is seized and the
user phones are disconnected. Under normal circumstances, the phone line seize should only be 1-2 minutes. However
line seize could last up to 15 minutes if trouble exists. If this occurs regularly, contact your installer.
32
Advertisement
