Advertisement
*Should beenabted on all telco nelworks which harie &led &y
discdnnect
(hanging up the phone for a percod 01 lime wtll cause dtsconnect of an
mcomtng call)
**The extended delay should only be used when
Otblttng
SatelllteS are
used to relay telco transmtsstons and an Ademco 685 Recetver. Sott-
ware Revtsmn 3.7 or hlgher IS used. When other
reCelverS
are used. CO
sull with the manufacturer
Communlcatlon
PROM Data Group 10
To program. set Rotary Switch to Position 10 ("Restore") and set switches
IOr
checked boxes as indicated.
DWlng ind Roporllng Characterbtka
&&oMn
(Check as desired):
SWITCHES
1
2
3
A
5
6
7
8
Comnnmlatlon
PROM Data Group 14
Communkallon
PROM Data Group 16
To program, set Rotary Switch to Positron 11 ("Not Used") and raise
To program. set Rotary Switch to Position 13 ("No1 User) ano rame
stitches tar checked boxes representing bfls set within the hexadecimal
switches tar checked boxes representing bits set wlthtn tne hexaosctmal
code.
code.
Memco Low Spnd/SESCONRadlonks
Roportlng Codas lor Lou 01
A.C. and &arm Rnton
(Select from 0 thru 9. B thru F)
Adomco Low SpoWSESCONRadlonks
Roportlng Co&s tar Zom
Bypass and Bypass Rrtom
(Select from 0 thru 9. B thru F)
I
I
I
I
I
-.
I
I
I
I
I I
I
I
I
I
I
I
I
Bit derghts
2
A
8
1
'2
A
8
*NOTES: 1. An entry is mandatory for these two codes (e.g.. 9) in the indi-
cated formats. even if there is no interest in receiving these
reports.
2. Regarding Alarm Restore. see note under PROM
Data Group 8 on page 15.
Communkatlan
PROM Data Group 15
To program, set Rotary switch to Positiin 12 ("Not Used") and raise
swllches for checked boxes.
Fh Zme &slgnatlon
tar 'BFSK" alarm rapwttng (check zones for
whiti desiied)
SWITCHES
1
2
3
4
5
6
7
8
t
NOTE: The 24 hour. trouble on open and pulsed sounder attributes of (ire
zones are separately Control PROM programmed.
1
2
A
8
1
2
4
8
Bit Welghts
*NOTE: An entry is mandatory tar these two codes (e g .9) in me MI-
cated tofmals even if there is no interest in recennng these
reports.
Cammunicatlon
PROM Dala Group 17
To program. set Rotary Stich to Position 1 A ("Not UserYt ona rame
switches for checked boxes representing bits sel wnhln the nexaoeclmal
code.
Msmco Low Speed/SESCOAlR~Ionlw
Roporttng Codas tar feat
and Low BaIte?y (Select from 0 thru 9. B thru F)
t
I
I
I
I
I
I
I
I
I
Bit ieights
2
A
8
1
2
A
8
*NO=
An entry IS mandatory for these two codes (e.g. 9) in the indicated
formats, even if there is no interest in receiving these reports.
17
Advertisement
