Table Of Contents; Safety - Generac Power Systems NEXUS Remote Monitor Instruction Manual

Table of Contents

TABLE OF CONTENTS
SAFETY ........................................................... Inside Front Cover
Read This Manual Thoroughly ........................................... 1
Safety Rules ..................................................................... 1
Operation and Maintenance ............................................... 2
How to Obtain Service ...................................................... 3
INTRODUCTION ........................................................................ 3
BATTERY INSTALLATION ........................................................... 3
NEXUS WIRELESS MONITOR OPERATION ................................. 3
Green LED (Generator OK) ................................................ 3
Yellow LED (Maintenance Needed) .................................... 3
Red LED (Contact Dealer) ................................................. 3
Pair/Reset Button .............................................................. 4
INSTALLATION .......................................................................... 4
Generator Side Transceiver Installation Instructions ........... 4
Display Unit Startup .......................................................... 6
Re-assemble the Generator ............................................... 7
Display Unit Mounting ....................................................... 7
ADDING A SECOND DISPLAY UNIT TO THE SYSTEM ................ 8
APPENDIX ................................................................................. 8
Retrofitting the Nexus Remote Monitor into a
Pre-2010 Model Generator ................................................ 8
FINAL ASSEMBLY DECAL DRAWING ......................................... 9
WARRANTY ...............................................................Back Cover

SAFETY

Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
FCC Interference Statement (Part 15.105 (b))
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential instal-
lation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
This portable transmitter with its antenna complies with FCC/IC RF
exposure limits for general population / uncontrolled exposure.
Section 7.1.5 of RSS-GEN
Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interfer-
ence that may cause undesired operation of the device.
To comply with FCC/IC RF exposure limits for general population
/ uncontrolled exposure, the antenna(s) used for this transmitter
must be installed to provide a separation distance of at least 20
cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.