Scanning The Channels - Radio Shack PRO-2055 User Manual

Beyond the Basics
output power. You can press
Stalker II stops on these undesired transmissions
to prevent the Signal Stalker II from stopping on
them in future sweeps, however, the Signal Stalker
II will still see their RF signal energy when sweeping
through the 1 MHz segment. This will cause the Signal
Stalker II to execute another fi ne step search of the
1 MHz segment. Of course, if you have locked out
the undesired transmissions, the Signal Stalker II will
not stop on them again, however, the overall sweep
performance of the Signal Stalker II will be impacted.
Signal Stalker II features a special lockout mode that
causes the scanner to skip a 1 MHz segment if fi ve or
more lockouts exist in that 1 MHz segment. To activate
this mode, press FUNC
mode. If a 1 MHz segment contains 5 or more lockouts
it will be skipped entirely while Signal Stalker II is
sweeping. Use FUNC
Stalker II frequencies.
To clear a locked-out frequency, select that frequency,
then press CLEAR.

scanning the channels

To begin scanning channels or to start scanning again
after monitoring a specifi c channel, press SCAN .
You must store frequencies into channels before
Notes Notes
the scanner can scan them. The scanner does not
scan through empty channels.
To change the scanning direction, press
The scanner scans through all channels (except those
you have locked out) in the active banks (see "Turning
Channel-Storage Banks Off and On"and "Locking Out
Channels or Frequencies").
L/OUT
e while in the Signal Stalker II
L/O
to review or clear locked Signal
57
when the Signal
e or d .