Radio Shack PRO-2055 User Manual page 31

The Basics
Press FUNC. Then press
Note Note
moves in the direction of the arrow pressed.
Press FUNC. Then hold down
number moves continuously in the assigned
direction.
Press
by one. Or, press
downward one by one.
2. Press PROG. M changes to P.
3. Use the number keys and ./DELAY to enter the
frequency (including the decimal point) you want
to store.
If you make a mistake, press CLEAR to delete a single
digit or press and hold CLEAR about 2 seconds to
delete all digits.
4. Press ENT to store the frequency into the channel.
If you made a mistake in Step 3, Invalid Freq.
Note Note
briefl y appears and the scanner beeps when you
press ENT. Start again from Step 3.
Your scanner automatically rounds the entered
frequency to the nearest valid frequency. For
example, if you enter a frequency of 151.553, your
scanner accepts it as 151.550.
All scanners tune by steps. Your RadioShack
scanner uses steps consistent with the latest US or
worldwide standards. If you enter a non-valid step
frequency, any scanner will tune to the next step.
Some scanner designs do this without showing
the correct step in the display. This scanner will
show the actual tuned frequency in the display.
Because steps are so close together, the audio
e . The channel number moves upward one
d . The channel number moves
or . The bank number
e d
or . The bank
e d
31