Scanning The Stored Channels; Manually Selecting Achannel - Radio Shack PRO-94 Owner's Manual

SCANNING THE STORED
CHANNELS
To begin scanning channels, press
scans through all non-locked channels in the activated
banks. (See "Locking Out Channels" on Page 34 and
"Turning Channel-Storage Banks On and Off" on
Page 33). When the scanner finds a transmission, it
stops on it. When the transmission ends, the scanner
resumes scanning.
Notes:
• If you have not stored frequencies into any chan-
nels, the scanner does not scan.
• If the scanner picks up unwanted partial, or very
weak transmissions, turn
decrease the scanner's sensitivity to these sig-
nals. To listen to a weak or distant station, turn
SQUELCH
• To ensure proper scanning, adjust
the audio mutes.
• To scan in the trunk scanning mode, see "Trunking
Operation" on Page 41.
MANUALLY SELECTING A
CHANNEL
You can continuously monitor a single channel without
scanning. This is useful if you hear an emergency
broadcast on a channel and do not want to miss any
details — even though there might be periods of silence
— or if you want to monitor a specific channel.
To manually select a channel, press
channel number then press
Or, if while scanning, the radio stops at a channel you
want to listen to, press
pressing
MAN
through the channels.) Press
ic scanning.
32
counterclockwise.
MAN again
MAN
at this time causes the scanner to step
. The scanner
SCAN
clockwise to
SQUELCH
SQUELCH
MAN
.
one time. (Repeatedly
to resume automat-
SCAN
until
, enter the