Advertisement
BLED5 INSTALLATION INSTRUCTIONS
ACCESSORIES
Bollard base:
Bollard base Retro kit: BOLBASE RETRO
Suffix "Y"
= Warm 3000K LED
Suffix "N"
= Neutral 4000K LED,
TROUBLESHOOTING
1. Check that the line voltage at fixture is correct. Refer
to wiring directions.
2. Is the fixture grounded properly?
3. Is the photocell is functioning properly (if used)?
BLED5
Cool LED Square Steplight
SLED Round: US pat. D612,974, CA Pat. pending,
CN Pat. pending
SLED Square:.US pat. D612,975, CA Pat. pending,
CN Pat. pending
BOLBASE
WIRING
Universal driver permits 120V to 240V, 50 or 60Hz.
1. Connect the black fixture lead to the (+) LINE
supply lead.
2. Connect the white fixture lead to the (-) COMMON
supply lead.
3. Connect the bare copper Ground wire from fixture to
supply ground.
(+)LINE
(-)COMMON
GROUND
GROUND
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool
enough to touch. Do not clean or maintain while
fixture is energized.
1. Clean glass lens with non-abrasive glass cleaning
solution
2. Do not open fixture to clean the LED.
BLEDR5
Cool LED Round Steplight
Note: These instructions do not cover all details or variations
in equipment nor do they provide for every possible situation
during installation, operation or maintenance.
BLACK
LIGHT
WHITE
FIXTURE
Advertisement
