Advertisement
BLED5 INSTALLATION INSTRUCTIONS
MOUNTING fIXTURES
For BLED5 & BLEDR5 the window is available on one side of Bollard. Secure Bollard before installing the housing.
1. Loosen Housing Screws and remove Mounting Plate. Screws will remain in place with O-ring retaining gaskets.
Fixture may hang from the tether while installing.
2. Place Bollard Gasket and Mounting Plate over recessed box.
3. Attach Mounting Plate with supplied Mounting Plate Screws.
4. Pull supply wires from box through mounting plate and wire fixture as shown in the wiring section.
5. Check Housing Gasket. It should remain firmly around the inside of the Housing.
6. Align Housing to Mounting Plate.
7. Make sure all gaskets are properly seated. Tighten Housing Screws.
8. Secure the Cap Gasket and tighten the Bollard Cap with supplied screws.
Housing
screws
Mounting
Housing
Plate
Bollard
Gasket
Bollard
Cap
Cap
Gasket
Bollard
Bollard
Cap
Cap
Gasket
Advertisement
