Advertisement
BLED5 INSTALLATION INSTRUCTIONS
MOUNTING fIXTURES
For BLED2x5 & BLEDR2x5, cutouts are provided on both sides of Bollard. Secure Bollard before installing the
housings.
1. Loosen Housing Screws and remove Mounting Plate. Screws will remain in place with O-ring retaining gaskets.
Fixture may hang from the tether while installing.
2. Place Bollard Gasket and Mounting Plate over cut out on Bollard.
3. Attach Mounting Plate with supplied mounting plate screws.
4. Pull supply wires from bollard through mounting plate and wire fixture as shown in the wiring section.
5. Check Housing Gasket. It should remain firmly around the inside of the Housing.
6. Align Housing to Mounting Plate.
7. Make sure all gaskets are properly seated. Tighten Housing Screws.
8. Follow same steps for second fixture.
9. Secure the Cap Gasket and tighten the Bollard Cap with provided screws.
Housing
Housing
screws
BLED5-IN-0612
Bollard
Cap
Gasket
Bollard
Mounting
Gasket
Plate
Bollard
Cap
Cap
Gasket
Mounting
Bollard
Plate
Gasket
Bollard
Cap
Bollard
Housing-
Housing
Screws
Gaskets
Advertisement
