Advertisement
VX/ VXBR CFL INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We'd like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com
LAMP INSTALLATION
CAUTION: Prior to installing, check that the lamp is
the correct wattage. Observe lamp manufacturer's
recommendations on lamp operation, ballast type and
burning positions.
1. Disconnect power. Make sure fixture and lamp are cool
enough to touch.
2. Open fixture by unscrewing guard and globe from
fixture.
3. Fully insert the lamp into the socket.
4. Replace globe and guard.
5. Tighten screws.
WIRING
Use supply wire rated for 90°C. The units are wired for
120V. Units built for a specific voltage are factory-wired
for the requested voltage. Make sure the supply voltage
is compatible with the unit. Multi tap units may be used
with a choice of 120V, 208V, 240V and 277V, provided
that proper ballast leads are connected in the field.
1. Connect the black fixture lead to the (+) LINE supply lead.
2. Connect the white fixture lead to the (-) COMMON supply
lead.
3. Connect the Ground wire from fixture to supply ground.
4. All unused leads must be capped and insulated.
(+)LINE
(-)COMMON
GROUND
GROUND
ACCESSORIES
Die Cast Guard:
Wire Clamp Flat Bottom:
Wire Clamp Round Bottom:
Easy Installation & Product Help
Tech Help Line
©2012 RAB LIGHTING Inc.
Call our experts 888 RAB-1000
Northvale, New Jersey 07647 USA
VX/ VXBR CFL-IN 0113
BLACK
LIGHT
WHITE
FIXTURE
GD100DG
GD200DG
GD100BAR
GD200BAR
GD100CL
GD200CL
REPLACEMENT LAMPS AND BALLASTS
Wattage
Compact Fluorescent Lamp
13
26
32
42
TROUBLESHOOTING
1. Is the proper lamp installed?
2. Make sure the lamp is not defective. Try a lamp known to
be in operating condition.
3. Check that the line voltage at fixture is correct. Refer to
wiring directions.
4. Is there voltage at the lamp socket? If there is no voltage,
check all connections.
5. Is the fixture grounded properly?
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool enough to
touch. Do not clean or maintain while fixture is energized.
1. Clean glass lens with non-abrasive glass cleaning solution.
2. As lamps age, light output diminishes. Mass re-lamping
at regular intervals ensures full light output at the highest
efficiency.
Note: These instructions do not cover all details or variations in
equipment nor do they provide for every possible situation during
installation, operation or maintenance.
rabweb.com
Visit our website for product info
RAB Lamp
RAB Ballast
Catalog#
Catalog#
LCFL13Q-4P
BCFL13-4E
LCFL26
BCFL42
LCFL32
BCFL42
LCFL42
BCFL42
email
Answered promptly sales@rabweb.com
Advertisement
