Line Trimmer Assembly; Installing The Trimmer Guard; Attaching The Running Wheel; Attaching The Plant Guard - Redback 106065 Operation Manual

2
4 Places
TRIMMER
GUARD
1
Figure 1
Figure 2
PLANT
GUARD
Figure 3
Figure 4

Line Trimmer Assembly

Installing the Trimmer Guard

The trimmer guard is an essential part of the line trimmer and must
ALWAYS be used to prevent damage to the trimmer and injury to
the operator. The guard is not attached to the trimmer when it is
delivered to avoid damage in transit. To attach the guard, loosen
and remove the 4 screws from the underside of motor housing (see
Figure 1). Place the guard on the motor housing
bores vertically. Screw in the 4 screws and tighten

Attaching the Running Wheel

Insert the running wheel into the holder on the left side of motor
housing and press, until it clicks (see Figure 2). To dismantle, the
retaining tab may be opened with a suitable tool.

Attaching the Plant Guard

The plant guard protects shrubs, trees and bedding plants. Insert
the plant guard into the holes of motor housing (see Figure 3). The
plant guard can be folded up when it is not needed (see Figure 4).
Assembling and adjusting the shoulder belt
Open retaining hook and hook onto the fastening eye on the
housing (see Figure 5). Adjust the shoulder belt to your height (see
Figure 6).
and align the
1
.
2
Figure 5
Figure 6
7