Set The Shaft Length; Set The Handlebar; Set The Operating Angle; Inserting And Replacing The Battery - Redback 106065 Operation Manual

Line Trimmer Assembly

Set the shaft length

Adjust the trimmer length to the height of the user (see Figure
7). Loosen the threaded sleeve on the shaft coupling
the lower shaft until the ideal handle length is reached
Tighten the threaded sleeve

Set the handlebar

Adjust the handlebar to the height of the user (see Figure
8). Loosen the locking lever on the handlebar
handlebar to the required position
folding down the locking lever.

Set the operating angle

Five operating angles can be adjusted on the lawn trimmer (See
Figure 9). This allows you to easily reach places in the garden
which are problematic and difficult to access. The cutting head
should always be parallel to the ground. Press the locking
button . Set the required operating angle
1
locking button.
Inserting/Replacing the Battery
Charge the battery as described in the charger operation
manual. Attach the charged battery into the power tool by
positioning, aligning and then sliding the battery into the power
receptacle on the line trimmer until it clicks into place (see
Figure 10). To remove, press the release button and pull out the
battery.
Protect the battery contacts when the battery is not being
used. Metal objects may short-circuit the contacts and pose
both an explosion and fire hazard!
8
.
3
. Set the
1
. Secure the handlebar by
2
. Release the
2
!
CAUTION
1
. Extend
1
.
2
3
2
2
Figure 7
1
Figure 8
2
Figure 9
BATTERY
RELEASE
Figure 10
1