Automatic Line Advance - Redback 106065 Operation Manual

Operation

Automatic line advance

You can advance the cutting line without stopping the motor. To
advance more cutting line, gently tap the cutting head on the
ground while running the lawn trimmer (see Figure 14). The line
blade in the guard cuts the line back to the correct length if too
much cutting line is advanced. It is best to bounce the cutting head
on bare ground or hard earth.
Work instructions
1. Attach the shoulder belt to the unit. Pull the shoulder belt over
your head. Hold the unit with both hands: one hand on the rear
handle, the other hand on the handlebar.
2. Keep the cutting attachment parallel to the ground and make
sweeping movements from side to side. Walk slowly forwards.
3. Use only the tip of the line for cutting, especially along walls.
If more than the tip is used for cutting, the cutting capacity is
reduced and the engine may overload.
4. Cut grass which is taller than 20 cm from the top down in
small stages to prevent premature wear of the line and engine
resistance.
5. Cut dry grass and weeds only.
6. The trim line may break by becoming entangled with foreign
objects, normal material fatigue, attempting to cut thick-stalked
weeds, striking walls, garden fences, etc.
Figure 14
11