Maintenance; Changing The Cutting Heed; Replacing The Line Spool - Redback 106065 Operation Manual

Maintenance

Before performing any maintenance on the line trimmer,
Changing the cutting head (see Figure 15)
1. Press and hold down the lock button
2. Loosen the cutting head by turning in an anti-clockwise
direction and remove
3. Attach the new cutting head by turning clockwise. Tighten
hand-tight.

Replacing the line spool

Note: Spare parts must conform with the requirements
specified by the manufacturer. Use original spare parts only
or spare parts authorized by the manufacturer.
Removal (see Figure 16)
1. At the same time press both catches together on the spool
cover and remove the cover
1
2. Remove the old line spool
3. Clean the spool housing, spring and cover with a clean
cloth.
Installation (see Figures 17 & 18)
1. Insert the spring (thin end upwards) into the spool housing
.
5
2. Pull the line ends of the new line spool out of the two
opposing retaining slots of the spool housing
3. Insert the new line spool into the spool housing
4. Re-attach the cover to the spool housing, ensuring that both
catches click into position
5. Pull on the line ends
retaining slots.
12
!
CAUTION
remove the battery.
.
1
.
2
.
2
and the spring
3
.
8
to release the lines from the
9
1
1
.
4
5
.
6
.
7
8
2
Figure 15
2
3
1
Figure 16
7
6
Figure 17
9
Figure 18
4
6
9