Figure 19
Figure 20
Maintenance
Winding the spool with new line
Note: Always use a cutting line with a maximum diameter
of 1/16" (1.6 mm). If a thicker line is used, the motor may
overheat or fail.
1. Remove the line spool as described on page 12.
2. Clean the line spool, remove residues of cutting line.
3. Take approx. 26 feet (8 meters) of new cutting line and fold
in half.
NOTE: Always use the specified line length! The line may not
be released automatically if it is too long.
1. Insert the folding end of cutting line into the retaining lug of
spool (see Figure 19).
2. Wind the lines in tight, even layers onto the lower and upper
halves of the spool. Observe the winding direction indicated
on the spool!
3. Press the line ends, approx. 6 inches (15 cm) into the two
opposing retaining slots (see Figure 20).
4. Install the line spool as described on page 12.
13