Charging The Battery; Maintenance - Redback 106487 Operation Manual

Maintenance

Before performing any maintenance on the line trimmer,
Replacing Trimmer Line
Always use a cutting line with a diameter of 0.095"(2.4mm) max.
If a thicker line is used, the motor may overheat or fail.
1. Insert the end of the cutting line into the retaining lug of the
spool on one side (see Figure 5).
2. Insert the end of the cutting line into the retaining lug of the
spool on the other side (see Figure 6).
3. Attach the joint snap into the spool housing (see Figure 7).
4. Place the spring over the post on the spool housing (see
Figure 8).
5. Attach the spool to the retainer (see Figure 9).
6. Attach the cover to the spool housing (see Figure 10).
7. Turn the top of the spool clockwise while holding the spool
housing to wind the cutting line on to the spool (see Figure 11).
10
!
CAUTION
remove the battery.
Figure 9
Figure 10
Figure 5
Figure 6
Joint
Snap
Figure 7
Spring
Figure 8
Figure 11