Cisco NCS 5500 Series Configuration Manuals page 68

Configure Neighbors for Nonbroadcast Networks
Step 4
area area-id
Example:
RP/0/RP0/CPU0:router(config-ospf)# area 0
Enters area configuration mode and configures an area for the OSPF process.
• The example configures a backbone area.
• The area-id argument can be entered in dotted-decimal or IPv4 address notation, such as area 1000 or
area 0.0.3.232. However, you must choose one form or the other for an area. We recommend using the IPv4 address
notation.
Step 5
network { broadcast | non-broadcast }
Example:
RP/0/RP0/CPU0:router(config-ospf-ar)# network non-broadcast
Configures the OSPF network type to a type other than the default for a given medium.
• The example sets the network type to NBMA.
Step 6
dead-interval seconds
Example:
RP/0/RP0/CPU0:router(config-ospf-ar)# dead-interval 40
(Optional) Sets the time to wait for a hello packet from a neighbor before declaring the neighbor down.
Step 7
hello-interval seconds
Example:
RP/0/RP0/CPU0:router(config-ospf-ar)# hello-interval 10
(Optional) Specifies the interval between hello packets that OSPF sends on the interface.
Step 8
interface type interface-path-id
Example:
RP/0/RP0/CPU0:router(config-ospf-ar)# interface TenGigE 0/2/0/0
Enters interface configuration mode and associates one or more interfaces for the area configured in Step 4.
• In this example, the interface inherits the nonbroadcast network type and the hello and dead intervals from the
areas because the values are not set at the interface level.
Step 9
Do one of the following:
• neighbor ip-address [ priority number ] [ poll-interval seconds ][ cost number ]
• neighbor ipv6-link-local-address [ priority number ]
database-filter [ all ]]
Example:
Routing Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.3.x
56
[ poll-interval seconds ][ cost number ] [
Implementing OSPF