Greenlee LPK1240 Instruction Manual page 23

Hydraulic oil can cause skin irritation.
• Handle the tool and hoses with care to prevent skin
contact with hydraulic oil.
• In case of accidental skin contact with hydraulic oil,
wash the affected area immediately to remove the
oil.
Failure to observe these precautions may result in
injury.
• Do not operate the tool without a set of dies in
place. Damage to the ram or crimping tool head
can result.
• Maintain proper footing to prevent loss of balance
in case of unexpected movement of the crimping
tool.
• Do not perform any service or maintenance other
than as described in this manual. Injury or
damage to the tool may result.
Failure to observe these precautions may result in
injury and property damage.
Greenlee / A Textron Company
LPK1230 and LPK1240 12-ton Hydraulic Crimping Tools
IMPORTANT SAFETY INFORMATION
Procedure for connecting or disconnecting hydraulic
hoses, fittings, or components:
1. Move the flow control lever on the hydraulic
power source to the OFF position.
2. Stop the hydraulic power source.
3. Follow the sequence under "Hose Connections"
to prevent pressure buildup. In case some
pressure has built up, loosen hoses, fittings, or
components slowly.
Emergency stop procedure:
1. Release the trigger.
2. Shut off the hydraulic power source.
Note: Keep all decals clean and legible, and replace
when necessary.
When disposing of any components (hydraulic hoses,
hydraulic fluid, worn parts, etc.), do so in accordance
with federal, state, and local laws or ordinances.
5
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070