Baud Rate Settings - AMX IRIS Operation/Reference Manual

Display Characters and P Modes (Cont.)
Characters Description
On
So
SP
P1-P2
P3
P4
P5
P6
P7
P8

Baud Rate Settings

The default communication setting for the IRIS unit is 9600 baud. You can change the baud rate with the
,
UP DOWN
running the IREdit software program to store HC functions.
The IRIS unit automatically sets the baud rate to 9600 when you connect power. If
you reset the baud to any other setting and disconnect power, the previous baud rate
setting is lost and the IRIS unit will default back to 9600 baud.
To set the baud rate:
1. Disconnect the power supply from the IRIS unit.
2. Press and hold the
pushbuttons.
3. The two digits that appear in the display represent the current baud rate setting. The following table
lists the RS-232 baud rates and corresponding display digits.
Baud Rate and Display Digits
Baud Rate
300
600
1200
2400
4800
9600
4. Press the
5. Press and hold the
lights to indicate the IRIS unit is ready to capture an HC function.
IRIS Infrared/Serial Data Capture Unit
P mode is on.
Send OK. HC function sent without errors to a PC running IREdit.
Special Function. Special mode to capture unusual HC functions.
Not used.
Sends HC functions to a PC running IREdit automatically after the VERIFY operation.
Disables the VERIFY operation to capture HC functions. Default mode requires the VERIFY
operation.
Loose-timing mode to capture JVC (PQ10956) HC functions.
Glitch-detection mode to capture Kinderman and some Mitsubishi HC functions.
Disables glitch-detection mode to capture non-carrier HC functions.
Strict-timing mode
, and pushbuttons. You must set the IRIS unit's baud rate to match the baud rate of the PC
SEND
, , and
UP DOWN
Display Digits
03
06
12
24
48
96
or pushbuttons to reset the baud rate.
UP DOWN
, , and
UP DOWN
pushbuttons. Reconnect the power supply and release the
SEND
pushbuttons again to set the new baud rate. The
SEND
Using the IRIS
READY LED
5