Capturing Hc Functions In Sp Mode; Capturing Difficult Hc Functions Using P3-P8 Modes; Display Characters And P Mode Settings - AMX IRIS Operation/Reference Manual

Using the IRIS
6. Press the
program.
7. Repeat steps 3 through 6 to capture all the HC functions on your list.

Capturing HC functions in SP mode

If you cannot capture an HC function in default mode, set the IRIS unit to special function (SP) mode.
Perform these steps to capture HC functions in SP mode:
1. Press and release the
the display and the
2. Perform the Capturing HC functions in default mode steps 3 through 6 four times, or until the
lights, to capture the HC function. Then, go to the next step.
LED
3. Simultaneously press and release the
mode. The message nO (normal operation) briefly appears in the display to indicate default mode is
active.
All settings are returned to their default state when power is removed from the unit.

Capturing difficult HC functions using P3-P8 modes

Set the IRIS unit to the P3-P8 modes if you cannot capture an HC function in default or SP mode, The P3
and P4 modes are special settings to capture HC functions. Perform these steps to capture HC functions
using P3-P8 modes:
1. Simultaneously press and release the
the display. The IRIS unit is now in P mode.
2. Use the
the following table.
3. Simultaneously press and release the
On and Off. The display then shows an On or Off message indicating the new P mode setting and
then immediately exits the P mode. You can activate multiple P modes to capture an HC function;
refer to theDefault Mode Settings table on page 3 for the P mode default settings when you connect
power to the IRIS unit.
4. Repeat the Capturing HC functions in default mode steps 3 through 6, on page 3, to capture the HC
function.

Display Characters and P Mode Settings

The following table lists the display characters and P mode settings for special HC devices.
Display Characters and P Modes
Characters Description
[ ]
Er
Nd
NO
OF
4
pushbutton to send the captured HC function to the PC running the IREdit software
SEND
and pushbuttons at the same time. The message SP briefly appears in
UP SEND
lights. The IRIS unit is now in SP mode.
UP LED
or pushbutton to select the appropriate P modes according to the descriptions in
UP DOWN
HC function is captured, analyzed, stored, and verified.
Error: HC function did not verify correctly.
No Device. Communication device error detected, or the IREdit program is not staged to
receive HC functions.
Normal Operation. Ready to capture HC.
P mode is off.
and pushbuttons to reset the IRIS unit to default
UP SEND
, , and pushbuttons. The message P1 appears in
UP DOWN SEND
, , and pushbuttons to toggle the P mode setting
UP DOWN SEND
IRIS Infrared/Serial Data Capture Unit
SEND