CHIEF FSA-1002 Installation Instructions

FLAT PANEL DESK CLAMP ACCESSORY
If you are missing any of the following components, please contact Customer Service at 1-800/582-6480.
(1) Desk Clamp Casting
(1) Thin Steel Washer
(1) Rotational Stop
(1) Clamp Bracket
(1) Alignment Bracket
BEFORE PROCEEDING, READ INSTALLATION INSTRUCTIONS COMPLETELY
FLAT PANEL DISPLAYS ARE EXTREMELY FRAGILE.
1. Using 3/16" hex key, remove the button head cap screw securing the monitor interface to the
arm or other modular flat panel arm component (i.e. Wall plate).
2. Assemble base (see Figure 2).
3. Attach components (see Figure 3).
4. Using the 3/16" hex key, tighten the button head cap screw located at arm pivot point (see
Figure 3 and Figure 4) until the desired amount of pivoting friction is achieved.
5. Refer to FCD manual for further installation instructions.
8804-000139 Rev. B
CHIEF MANUFACTURING INC. 1-800-582-6480, Fax: 1-877-894-6918, Email: chief@chiefmfg.com
INSTALLATION INSTRUCTIONS
FSA-1002 and KFSA-1002
Prior to assembly, unpack carton completely and verify contents.
(1) Grommet Bracket
(1) Rotational Stop Spacer
(1) Button Head Cap Screw 4.0" Long
(1) Socket Head Cap Screw .625" Long
(3) Flat Head Cap Screw 10mm
Figure 1
(1) 2.5mm Hex Key
(1) 5/32" Hex Key
(1) 3/16" Hex Key
12/09/04