Accessories; General; Security - Husqvarna AUTOMOWER 550 Operator's Manual

1. Slide the horizontal bar to specify the required
angles in degrees for the sectors, and proportion as
a percentage.
3.17.5 Reversing distance
This functions allows you to control how far the robotic
lawnmower reverses out from the charging station
before it starts mowing. This is a useful function for
instance if the charging station is placed way in under a
veranda or in another limited space area.
1. Slide the horizontal bar to specify the required
reversing distance. The default setting is 60 cm / 24
in.
3.17.6 Drive past wire
The front of the robotic lawnmower always passes the
boundary wire by a specific distance before the mower
turns around. The default distance is 31 cm / 12 in., but
this can be changed if required. A figure between 20
(cm) and 50 (cm) can be selected.
Note: The distance given is only an approximate value
and should be regarded as a guide. The actual distance
the robotic mower passes the boundary wire can vary.
1. Slide the horizontal bar to specify how much the
robotic lawnmower should pass the boundary wire.

3.18 Accessories

Settings for accessories mounted on the mower can be
made in this menu.
ACCESSORIES
Mower house
Ultrasonic
3.18.1 Mower house
When this option is enabled, the wear on the mower and
the house is reduced, but it can result in more uncut
grass around the charging station.
3.18.2 Ultrasonic
Ultrasonic is applicable for Automower
that the robotic lawnmower reduces speed before it hits
an obstacle. This function can be disabled, which means
the robotic lawnmower will always operate at a lower
speed.

3.19 General

This function is used to set time and date, or to reset to
default settings.
General menu is only available for short-
Note: The
range connectivity (Bluetooth).
30 - Installation
3.19.1 Time & Date
This function allows you to set current time and date
manually, or to choose to get it from the mobile device.
Set time: Tap Edit , then enter the correct time and
•
tap
Set date: Tap Edit , then enter the correct time and
•
tap
3.19.2 Reset to factory settings
This function allows you to reset the robotic lawnmower
to the factory default settings.
The following settings are however not altered:
• Security level
• PIN code
• Loop signal
• Messages
• Date & Time
1. Select
2. Confirm by choosing

3.20 Security

Through this selection, settings relating to security and
the connection between the robotic lawnmower and the
charging station can be made.
®
550. It ensures
3.20.1 New loop signal
The loop signal is randomly selected to create a unique
link between the robotic lawnmower and the charging
station. In rare cases, there may be a need to generate
a new signal, for instance if two adjacent installations
have a very similar signal.
1. Place the robotic lawnmower in the charging station.
2. Select
3. Await confirmation that the loop signal has been
generated. This normally takes about 10 seconds.
GENERAL
Time & date
Reset to factory
settings
OK .
OK .
Reset to factory settings .
Reset .
SECURITY
New loop signal
Change PIN code
Theft protection
GeoFence
Create new loop signal .
362 - 002 - 06.02.2018