Husqvarna AUTOMOWER 550 Operator's Manual page 31

3.20.2 Change PIN code
Note: Changing the PIN code is not possible if the LED
indicator lamp on top of the robotic lawnmower is either
red (error) or green (mowing).
1. Enter the current PIN code.
2. Enter the new PIN code.
3. Confirm by entering the same code again.
Make a note of the new PIN code on the designated line
Introduction on page 3 .
in Memo. See
3.20.3 Theft protection
In the Theft protection menu it is possible to set the
alarm duration and also what events should trigger the
alarm.
Theft protection
Alarm duration
Lifted
Turned upside down
STOP button pressed
Time lock
3.20.3.1 Alarm duration
There is a possibility to set how long the alarm signal
should last. A setting between 1 and 10 minutes is
possible.
3.20.3.2 Lifted
If the alarm Lifted is enabled, the robotic lawnmower
senses changes in the lift sensors, and the alarm goes
off.
3.20.3.3 Turned upside down
Turned upside down is enabled, the robotic
If the alarm
lawnmower senses changes in the tilt sensors, and the
alarm goes off.
3.20.3.4 STOP button pressed
"STOP button pressed" is enabled, the
If the alarm
alarm goes off if someone presses the STOP button. To
avoid alarm, the operator must be within short-range
(Bluetooth).
Note: After an alarm has been triggered, you must be
close by the robotic lawnmower, and clear the alarm in
the app by entering the PIN code (only available for
short-range Bluetooth connectivity).
3.20.3.5 Time lock
A time lock can be set to decide how many days will
pass before the PIN code must be entered. This means
that the robotic lawnmower cannot be operated/
controlled without first entering the correct PIN code.
When the time limit has passed the robotic lawnmower
continues to mow as normal, but the PIN code must be
entered before any new commands or settings can be
done. When the PIN code is entered, the robotic
362 - 002 - 06.02.2018
lawnmower is ready to continue operating. A setting
between 1 to 100 days is possible, and the default
setting is 30 days.
3.20.4 GeoFence
The GeoFence function makes it possible to track the
movement of the robotic lawnmower, for example in
case of theft.
GeoFence
Before GeoFence can be used, its center point (origin)
must be set. This is either done during the first start-up
sequence, or in the Security menu.
Note: It is only possible to set the center point in
GeoFence with short-range connectivity (Bluetooth).
Note: The robotic lawnmower must have access to GPS
satellites to be able to set a GPS position. If the
charging station is placed in a mower house, under a
roof or a large tree, try to place the robotic lawnmower
out on the lawn. Then try to set GeoFence again.
Settings > Security > GeoFence in the
1. Select
®
Automower Connect app.
2. Enable GeoFence by tapping on the On/Off bar.
3. Save the GeoFence setting.
The GeoFence radius is 500 m.
When putting the robotic lawnmower into storage for a
long period, such as during the winter, Husqvarna
recommends turning off the main switch. With the
GeoFence function activated, you will need the PIN
code in order to turn off the robotic lawnmower. Once
the main switch has been turned off, the function will
stay active for another 12 hours. After that it will not be
possible to communicate with the robotic lawnmower
and the GeoFence function will not be active.
GeoFence
Installation - 31