Husqvarna AUTOMOWER 550 Operator's Manual page 47

Message Cause
Charging station
The contact between the charging strips and
blocked
contact strips may be poor and the robotic
lawnmower has made a number of attempts
to charge.
An object is obstructing the robotic lawnmow-
er.
The charging station is tilted or bent.
Stuck in charging sta- There is an object in the way of the robotic
tion
lawnmower preventing it from leaving the
charging station.
Upside down
The robotic lawnmower is leaning too much
or has turned over.
Needs manual charg-
The robotic lawnmower is set to the
ing dary area operating mode.
Next start hh:mm
The timer setting prevents the robotic lawn-
mower from operating.
The clock on the robotic lawnmower is not
correct.
Lifted
The lift sensor has been activated as the ro-
botic lawnmower has become trapped.
Collision sensor prob-
The body of the robotic lawnmower can not
lem, front/rear
move freely around its chassis.
Wheel drive problem,
Grass or other object is wrapped around the
right/left
drive wheel.
Alarm! Mower stop-
The alarm was activated because the mower
ped
was stopped.
Alarm! Mower lifted
The alarm was activated because the mower
was lifted.
Alarm! Mower tilted
The alarm was activated because the mower
was tilted.
Electronic problem
Temporary electronic or software related is-
sue in the mower.
Loop sensor problem,
front/rear
Charging system
problem
Tilt sensor problem
Temporary problem
Temporary battery
Temporary battery or software related issue
problem in the mower.
Battery problem
362 - 002 - 06.02.2018
Action
Put the robotic lawnmower in the charging
station and check that the charging strips and
contact strips make good contact.
Remove the object.
Confirm that the charging station is placed on
a fully flat and horizontal ground. The charg-
ing station must not be tilted or bent.
Remove the object.
Place the robotic lawnmower on a flat, level
surface, and start the robotic lawnmower
again.
Secon-
Place the robotic lawnmower in the charging
station. This behaviour is normal and no ac-
tion is required.
Change the timer settings. See
tings on page 26 .
Set the time. See
Free the robotic lawnmower.
Check that the body of the robotic lawnmower
can move freely around its chassis.
If the problem remains, the message requires
action by an authorized service technician.
Clean the wheels and around the wheels.
Adjust the mower security settings in the
curity menu, see Security on page 30 .
Restart the mower.
If the problem remains, the message requires
action by an authorized service technician.
Restart the mower.
Disconnect and reconnect the battery.
If the problem remains, the message requires
action by an authorized service technician.
Edit timer set-
Timer on page 24 .
Se-
Troubleshooting - 47