Table of Contents
Advertisement
Installation Information
Door Panel Removal and Installation (All Models)
METAL DOOR PANELS MAY HAVE SHARP EDGES.
PROTECTIVE GLOVES SHOULD BE WORN WHEN
HANDLING PANELS.
DOOR PANELS MAY BE HEAVY OR UNSTABLE. IF
THEY WERE TO FALL, THEY COULD CAUSE SERI-
OUS PERSONAL INJURY.
Classic, carBon and Platinum Stainless Steel Door
Panel Removal and Installation (424-2)
To remove a 424-2 SS door panel, the door must first
be removed from the unit.
To Remove the Door:
1. Remove mounting screws securing door closer to
the unit base (See Figure 2-19)
2. Slide door closer down off of bottom door hinge pin
NOTE: It may be necessary to lean unit back
slightly to create enough clearance between hinge
pin and floor.
3. Open door and extract screws from top door hinge.
4. Lean door away from unit slightly and lift door out of
bottom cabinet hinge.
To Remove a Stainless Steel Panel:
1. Lay door down and remove bottom door hinge and
switch depressor. (If lock and/or screws are pres-
ent on bottom handle side, remove them also.)
2. Remove Poly-tape under gasket on handle side
which covers handle mounting screw holes (See
Figure 2-20).
NOTE: Do not discard tape. It must be reapplied
when panel is reinstalled.
3. Extract handle mounting screws and pull handle
from front of door (See Figure 2-21).
4. Lift stainless steel panel from door.
NOTE: To install stainless steel panel, reverse steps
above.
#3758410 - Revision C - May, 2014
Wine Storage
Wine Storage
Figure 2-19. Door Closer Removal
Door Frame
Figure 2-20. Poly Tape Removal
(
Door Hinges &
Screws - not shown)
SS Panel
SS Handle
Figure 2-21. Stainless Steel Door Panel Removal
2-8
Series
Series
2
2
(400-
)
(400-
)
Hinge Pin
Door Assy
Door Closer
Door Gasket
Poly Tape
Handle
Screws
Poly
Tape
Hide quick links:
Advertisement
Table of Contents
