Table of Contents
Advertisement
Installation Information
Framed & Overlay Door Panel Removal / Installation
(430-2)
Framed and overlay panels are attached to the door by
sliding 1/4" (6 mm) thick edge of panel under door trim.
On the handle side, there may also be additional
screws passing through the door frame from rear into
the panel for increased support. Overlay handles may
also be attached through the door frame, or just through
the panel.
To remove a framed or overlay panel, the handle, or
trim on handle side must first be removed. Handles
and/or handle-side trim is secured to the door with
screws. The screw heads are then concealed by a
magnetic trim strip.
To Remove Handle or Handle-side Trim (See Figure
7-30 & 7-31):
1. Press a sticky piece of tape to center of magnetic
trim strip.
2. Pull tape so that trim strip bows away from door,
disengaging both ends of trim strip from the end-
caps.
3. With mounting screws exposed, extract the screws,
then pull handle (or handle-side trim) from door.
To Remove Panel (See Figure 7-31):
1. Slide panel towards handle side, and out from
under door trim.
NOTE: If the panel will not slide from under door
trim, panel mounting screws and/or handle mount-
ing screws may have been used.
a. Open door and remove Poly-tape from under
gasket.
b. Extract panel mounting screws, and/or handle
mounting screws.
c. Slide panel towards handle side, and out from
under door trim.
#3758410 - Revision C - May, 2014
Wine Storage
Wine Storage
Figure 2-30. Trim Molding Removal
Handle or
Handle-side
Trim
Screws
Framed or
Overlay Panel
Figure 2-31. Framed and Overlay Handle / Handle
Side Trim & Door Panel Removal
2-12
Series
Series
2
2
(400-
)
(400-
)
Magnetic
Trim Molding
Piece of
Tape
Hide quick links:
Advertisement
Table of Contents
