Drawer Panel Removal And Installation (427R-2) - Sub-Zero 424HAG/O-2 Service Manual

Installation Information
Door Panel Removal and Installation
(427-2 & 427R-2)
Models 427-2 and 427R-2 are NOT supplied with pan-
els from the factory. Panels are purchased separately.
Door panels are attached with screws passing from the
rear through the door frame into the panel. The handle
is attached to the panel.
To remove a door panel:
1. Open door.
2. Remove Poly-tape under gasket which covers
panel mounting screw holes (See Figure 2-24).
NOTE: Do not discard tape. It must be reapplied
when panel is reinstalled.
3. Extract panel mounting screws. (See Figure 2-25)
4. Pull panel from door.
NOTE: To install panel, reverse steps above.

Drawer Panel Removal and Installation (427R-2)

NOTE: Model 427R-2 is NOT supplied with panels
from the factory. Panels are purchased separately.
Drawer panels are attached using screws passing
through mounting brackets at the bottom of each draw-
er, and a dog-eared bracket on the back of the panel fit-
ting into slots in the face of the drawers. Handles are
attached to the panels.
To remove a drawer panel (See Figure 2-26):
1. Open drawer.
2. Extract the six screws at bottom drawer panel
bracket.
3. Pull bottom of drawer panel out slightly while pulling
downward.
NOTE: To install panel, reverse steps above.
#3758410 - Revision C - May, 2014
Wine Storage
Wine Storage
Door Frame
Figure 2-24. Poly Tape Removal
Figure 2-25. Door Panel Removal
Figure 2-26. Drawer Panel Removal
2-10
Series
Series
2
2
(400- )
(400- )
Door Gasket
Poly Tape
Drawer Panel
Mounting Bracket
- Upper
Drawer Panel
Mounting
Bracket
- Bottom