Guarantee; Important Notice / Disclaimer - Polygon Technologies Micro Commander GC0101 User Manual

Cause 2: "Do Not Check Airtime" is enabled
You may have disabled airtime checking by ticking the box labeled "DO NOT Check Airtime" which is
located in "Supplementary Data Services" under the "SETTINGS TAB".
Cause 3 : Reception problem
You may have bad reception in your area, preventing the unit from communicating with the
network. Please check using a regular cellular phone that there shows 1-2 bars of signal right next
to the Micro Commander. Refer to Section 5.5 (Antenna)
15.5. Micro Commander does not respond to Voice Calls
Cause 1: Caller ID on phone is disabled
Your Caller ID feature on your phone may be deactivated. Please refer to your phone's manual on
how to enable this feature.
Cause 2: Bad configuration
You may have configured the unit incorrectly. Make sure the number you are calling from is stored in
the "Numbers List" on the Micro Commander.

16. GUARANTEE

The Micro Commander is guaranteed for a period of 24 months against defects in materials or
workmanship. Should your product become defective during the guarantee period it will be repaired
or replaced at the sole discretion of Polygon Technologies under the following conditions:
A: The unit must not have been opened or otherwise tampered with. If the enclosure of any unit has
been opened at all, the guarantee will be null and void.
B: The guarantee does not cover damage resulting from excessive input voltages, lightning, power
surges or water ingress.
A decision about issues A and B will be at the sole discretion of Polygon Technologies.
guarantee does not provide for shipping costs. This will be for the account of the user under all
circumstances.

17. IMPORTANT NOTICE / DISCLAIMER

Herein, "the Company" will mean:
Polygon Technologies CC, its directors, members, employees and agents.
Much effort has been made to ensure the contents of this manual are complete and without errors.
Nonetheless, the Company cannot be held liable for any damages directly or indirectly resulting
from any errors in this manual.
The Company will under no circumstances be held liable for any injuries/death or damages that
result from the use of this product, irrespective of whether such injuries/death or damages resulted
from a faulty product or negligence of any kind on the part of the Company.
All Information and images in this manual are proprietary to Polygon Technologies CC. The manual
as a whole may be distributed and copied freely, but no partial content may be used/copied or
distributed in any way. No part of the product (including the hardware, firmware and software) may
be copied or reverse-engineered.
Polygon Technologies CC reserves the right to make changes to contents of this manual, without
notice, at any time.
© Polygon Technologies. All rights reserved
This
Page 35