Supported Then Actions - Polygon Technologies Micro Commander GC0101 User Manual

8.2. Supported THEN Actions

8.2.1. THEN Change Output
A statement containing this Action, will change the selected output according to specified actions.
The user can choose between the following five actions:
• Activate for a time
• Activate for a time – Pause – Activate for a time
• Activate (Leave Activated)
• De-Activate (Leave De-Activated)
• Change State
If the user chooses:
➢ "Activate for a time"
"
Activate for a time – Pause – Activate for a time
➢
number of seconds specified. The output will remain off for a selected period, after which it will again
activate for the selected number of seconds.
"
Activate (Leave Activated)
➢
applies to "
De-Activate (Leave De-Activated)".
" ", it will either change the state of the selected output, meaning that it will active it if it
Change State
➢
was de-activated and vice versa.
8.2.2. THEN Send Message
A statement containing this Action, will send a message via SMS to each of up to 6 selected recipients or a
message via Serial port or a message to our server.
The user can choose between the following fourteen options:
• Plain Message
• Input/Output Status
• General Status
• Global Input Status
• Global Output Status
• Please Call Me
• Log Status to Sever
If the user chooses:
, it will send a predefined message either via SMS to each of up to 6 selected recipients,
➢ "Plain Message"
via the serial port or to server*.
➢ "Input/Output Status"
the status of the selected input or output either via SMS to each of up to 6 selected recipients.
➢ "General Status"
recipients containing the following information: date & time, signal strength, firmware version, serial
number, airtime remaining, status of mains power.
, it will send a message either via SMS to each of up to 6 selected recipients containing the
➢ Input Status"
status of the input.
, it will send a message either via SMS to each of up to 6 selected recipients containing
➢ "Output Status"
the status of the output.
➢ "Please Call Me",
© Polygon Technologies. All rights reserved
, it will Activate the selected output for the selected number of seconds specified.
", it will Activate the selected output and leave it activated. The inverse
, it will send a predefined message(one for active and one for inactive) regarding
, it will send a general status message either via SMS to each of up to 6 selected
it will send a "Please Call Me" message via SMS to each of up to 6 selected recipients .
", it will Activate the selected output for the selected
Page 26