Set Gprs Logging Interval; Reset Micro Commander - Polygon Technologies Micro Commander GC0101 User Manual

7.10. Set GPRS logging interval

This set of commands allows you to override the GPRS logging interval that the GSM Commander may
have been configured with and can only be sent from the administrator number. These override
settings are non-volatile, which means their effect will remain after power has been cycled.
ADMIN GPRSSETUP.LOG5
(GPRS logging interval will be set to every 5 minutes)
ADMIN GPRSSETUP.LOG10
(GPRS logging interval will be set to every 10 minutes)
ADMIN GPRSSETUP.LOG15
(GPRS logging interval will be set to every 15 minutes)
ADMIN GPRSSETUP.LOG30
(GPRS logging interval will be set to every 30 minutes)
The GSM Commander will reply with a confirmation message.

7.11. Reset Micro Commander

This command can be sent from ANY number. To reset the Micro Commander you must send:
RESET GSMC
The Micro Commander will NOT reply with a confirmation message.
© Polygon Technologies. All rights reserved
Page 21