Heat & Glo PRIMO48 Installation Instructions Manual page 4

• Install the HEAT-ZONE-PRIMO collars on the left and
right sides of the appliance with screws. See Figure 3.
• Attach included air duct to the HEAT-ZONE-PRIMO
collars with gear clamps. See Figure 4.
• Attach both mounting brackets to the fan housing.
See Figure 4.
• Mount fan housing in desired location. See Figures 1,
6 and 7.
• Attach round to oval adapter to fan housing with two
screws. See Figure 4.
• Attach included fl exible ducts to round to oval adapter
with gear clamps.
Note: 6 Inch metal duct can be used in place of the in-
cluded fl exible ducts.
WARNING! Risk of Fire! HEAT-OUT-PRIMO seal plates
MUST remain installed. Appliance could overheat.
HEAT ZONE ® COLLAR LOCATION
LEFT AND RIGHT SIDES
DO NOT
REMOVE
KNOCKOUTS
Figure 3. HEAT-ZONE-PRIMO
WARNING! Risk of Fire! DO NOT fold/kink/pinch/ob-
struct 6 inch fl exible ducts. Appliance could overheat.
4
SQUARE
VENT
PIPE GASKET
HEAT-OUT-PRIMO
SEAL PLATES
Heat & Glo • HEAT-ZONE-PRIMO Instructions • 2310-936 Rev. E • 7/16
Mounting Bracket
(Both Sides)
Screws
Gear Clamp
Figure 4.
MINIMUM SPACE
18 in.
REQUIRED FOR
90 DEGREE BEND
Figure 5.
Fan Housing
Round to Oval Adapter
Gear Clamp
6 in. Round Air Duct
6-3/4 in.