Table of Contents
Advertisement
34
5.
Remove the empty bobbin (9).
6.
Insert the full bobbin into the bobbin case (5).
Make sure that the driver hole (10) is pointing to the bobbin
case.
7.
Press in the bobbin case (5) until the latch engages.
8.
Feed the hook thread through the slot (8).
9.
Feed the hook thread under the thread tension spring (7) and
to the slot (6).
10. Pull the hook thread out 100 mm to 150 mm through the slot (6).
11. Put the cover back on.
12. Hold the needle thread in place until the thread lever is at top
dead center and the hook thread is tied to the needle thread.
13. Elongate needle thread and hook thread.
14. Shorten needle thread and hook thread to 70 mm.
15. Switch on the machine.
Important
Hold both threads in place when starting to sew for the first time.
4.7
Thread tension
Together with the hook thread tension, the needle thread tension
influences the final seam pattern. With thin sewing material,
excessive thread tension can lead to undesired gathering and
thread breakage.
Proper setting
If the tension of needle thread and hook thread is identical, the
thread interlacing lies in the middle of the sewing material.
Set the needle thread tension so that the desired seam pattern is
achieved with the lowest possible tension.
Operating Instructions 967 - 02.0 - 11/2016
Operation
Advertisement
Table of Contents
