Mounting The Receiver; Wiring The Receiver To Hunter Controllers - Hunter Rain-Clik Owner's Manual

Mounting the Receiver

Wiring the Receiver to Hunter Controllers

1. Remove the sensor jumper across the two SEN
terminals in the controller.
2. Attach the two yellow wires to the 24 VAC terminals.
3. Attach the blue wire to one SEN terminal and the white
wire to the other SEN or SEN COM terminal.
Note:
Additional setup steps required for
Hydrawise®, ACC, and ACC2 controllers.
• Hydrawise Controllers: Complete the installation by
configuring the sensor in your Hydrawise account.
• ACC Controllers: Use features at the "Set Sensor
Operation" dial position on ACC to complete setup.
• ACC2 Controllers: Use "Devices and Sensor Response"
options on ACC2 to complete setup.
https:/ /hunter.help/hydrawisesensor
https:/ /hunter.help/acc2sensor
6
24VAC REM
X2™ and X-Core®
Pro-HC
S1 S1 S2
GND AC1 AC2 REM
I-Core®
SCAN
for help
AC2
AC1
SEN C
GND
SEN
SEN
Pro-C® or HPC
SEN
SEN
TEST
REM
24VAC
24VAC
GND
ICC2
+ + + +
24
S2 C C SEN4 SEN3 SEN2 SEN1 VAC
– – – –
C P/MV SEN4 SEN3 SEN2 SEN1 COM
ACC
24V
24V
SENSOR 1
SENSOR 2
COMMON
HC
SEN 1
SEN 2
SEN C
REM
24VAC
24VAC
GND
HCC
SEN1 –
+ SEN1
SEN2 –
+ SEN2
SEN3 –
+ SEN3
P/MV3 COM
24VAC COM
ACC2