EN
Gravity Feed Spray Guns
See note below
2
5
Fluid Tip
(Torque to
15-20 ft. lbs.)
See note below
7
8
9
10
NOTE: If the color of these parts is blue or black,
then the parts marked with a "*" below are not
required and should not be used.
PARTS LIST
Ref.
Replacement
No.
Part No.
1
JGA-4035-K5
*2
JGS-72-K10
3
---
4
---
GTI-33-K5
■5
6
---
7
---
*8
---
*9
---
*10
---
11
KGP-13-K5
12
---
13
---
14
---
15
GTI-428-K5
16
---
Suffixes -K5, -K10 designates kits of multiple parts.
Example: JGA-4035-K5 is a kit of 5 packings.
■ Some gun models do not require a baffle seal. If white seal is present, order GTI-33-K5.
www.carlisleft.com
4
3
11
12
1
2
6
Qty. of
Parts in
Description
Packing
Gasket Kit (PTFE)
Fluid Needle Spring
Spring Pad
Baffle Seal
Air Valve Spring
Air Valve
U Cup Seal
Washer
Snap Ring
Cup Gasket
(Gravity Guns Only)
Retaining Clip
Seal
Pin
Clip, Seal & Pin Kit (5 ea.)
Fluid Inlet Gasket (PTFE)
(Suction and Pressure
Feed Guns Only)
Suction and Pressure Feed Spray Guns
See note below
2
14
13
15
5
Fluid Tip
(Torque to
15-20 ft. lbs.)
See note
below.
7
8
9
10
Fluid Inlet Adapter
(Torque to 20-25 ft. lbs.)
Use medium strength thread
sealant (i.e. Devcon #2242 blue
or equal) on threads.
PREVENTIVE MAINTENANCE
To clean air cap and fluid tip, brush exterior with a stiff bristle
Kit
brush. If necessary to clean cap holes, use a broom straw or tooth-
1
pick if possible. If a wire or hard instrument is used, extreme care
2
must be used to prevent scratching or burring of the holes which
1
will cause a distorted spray pattern.
1
1
To clean fluid passages, remove excess material from cup, then
1
flush with a suitable solvent. Wipe gun exterior with a solvent
1
dampened cloth. Never completely immerse in solvent as this is
1
detrimental to the lubricants and packings.
1
1
FLUID INLET GASKET (16) REPLACEMENT INSTRUCTIONS
1
1. Remove fluid inlet adapter with appropriate wrench.
1
2. Clean Loctite from gun body inlet threads and seal area.
1
3. Place gasket (16) squarely onto the fluid inlet adapter and push
1
it down until it is flat against the shoulder.
1
4. Use medium strength thread sealant (i.e. Devcon #2242 blue,
1
or equal) on threads before installing fluid inlet adapter.
5. Torque fluid inlet adapter to 20-25 ft. lbs. and tighten locknut.
2 / 4
4
3
12
1
16
2
6
SI-2-25-33-R1 (6/2018)
14
13
15